Toyo Si-450IV

Item			Si-450IV
	Injection unit type	-	I			J			K
	Screw diameter	mm	55	60	68	60	68	75	68	75	83
	Theoretical injection capacity	cm3	522	763	980	763	1111	1351	1111	1656	2028
II injection unit	Injection unit	-	I450B			J450B			K600B
	Max. injection speed	mm/s	200			180			180
	Max. injection pressure	MPa	235.2	196.0	151.9	215.6	166.6	137.2	215.6	176.4	147.0
III injection unit	Injection unit	-	I600B			J750B			-
	Max. injection speed	mm/s	300			300			-
	Max. injection pressure	MPa	225.4	186.2	147.0	215.6	166.6	137.2	-
	Clamping force	kN	4410
	Tie bar clearance (H×V)	mm	870 X 870

• ・The figures are subject to change without any legal obligation on the part of the manufacture.
• ・The specifications are expressed in SI units.（1MPa=10.2kgf/cm²、1kN=0.102tonf）
• ・The maximum injecting pressure is attainable maximum set values. This value may be limited by molding conditions and cycle time.
• ・The maximum injecting speed is calculated values. This value may be limited by set injecting pressures.
• ・A large-sized screw may not be applicable to some kinds of material.