Toyo Si-180IV

Item			Si-180IV
	Injection unit type	-	F								G
	Screw diameter	mm	28	32	36	40	32	36	40	46	40	46	50	55
	Theoretical injection capacity	cm3	69	103	147	201	103	147	201	266	201	306	393	475
I injection unit	Injection unit	-	F75B				-				-
	Max. injection speed	mm/s	150				-				-
	Max. injection pressure	MPa	274.5	235.4	191.1	156.8	-				-
II injection unit	Injection unit	-	F200HB				F200B				G300B
	Max. injection speed	mm/s	300				210				210
	Max. injection pressure	MPa	274.5	250.0	196.0	161.7	264.0	250.0	215.6	166.6	244.0	215.6	186.2	156.8
III injection unit	Injection unit	-	-				F400B				G450B
	Max. injection speed	mm/s	-				400				300
	Max. injection pressure	MPa	-				264.0	250.0	215.6	166.6	244.0	215.6	186.2	156.8
	Clamping force	kN	1764
	Tie bar clearance (H×V)	mm	560 X 560

• ・The figures are subject to change without any legal obligation on the part of the manufacture.
• ・The specifications are expressed in SI units.（1MPa=10.2kgf/cm²、1kN=0.102tonf）
• ・The maximum injecting pressure is attainable maximum set values. This value may be limited by molding conditions and cycle time.
• ・The maximum injecting speed is calculated values. This value may be limited by set injecting pressures.
• ・A large-sized screw may not be applicable to some kinds of material.