Toyo Si-100IV

Item			Si-100IV
	Injection unit type	-	CH				D
	Screw diameter	mm	20	24	28	24	20	24	28	32
	Theoretical injection capacity	cm3	23	43	59	43	23	43	69	90
I injection unit	Injection unit	-	-			-	D75B
	Max. injection speed	mm/s	-			-	300
	Max. injection pressure	MPa	-			-	274.5	235.4	182.3	-
II injection unit	Injection unit	-	-			-	D150B
	Max. injection speed	mm/s	-			-	300
	Max. injection pressure	MPa	-			-	-	274.5	235.2	181.3
III injection unit	Injection unit	-	CH150B(CH300B)			CH450B	D300B
	Max. injection speed	mm/s	500(700)			1000	500
	Max. injection pressure	MPa	235.3 (254.9)	215.7 (235.3)	156.9 (182.4)	294.1	-	274.5	235.2	181.3
	Clamping force	kN	980
	Tie bar clearance (H×V)	mm	460 X 410

Item			Si-100IV
	Injection unit type	-	F
	Screw diameter	mm	28	32	36	40	32	36	40	46
	Theoretical injection capacity	cm3	69	103	147	201	103	147	201	266
I injection unit	Injection unit	-	F75B				-
	Max. injection speed	mm/s	150				-
	Max. injection pressure	MPa	274.5	235.4	191.1	156.8	-
II injection unit	Injection unit	-	F200HB				F200B
	Max. injection speed	mm/s	300				210
	Max. injection pressure	MPa	274.5	250.0	196.0	161.7	264.0	250.0	215.6	166.6
III injection unit	Injection unit	-	-				-
	Max. injection speed	mm/s	-				-
	Max. injection pressure	MPa	-				-
	Clamping force	kN	980
	Tie bar clearance (H×V)	mm	460 X 410

• ・The figures are subject to change without any legal obligation on the part of the manufacture.
• ・The specifications are expressed in SI units.（1MPa=10.2kgf/cm²、1kN=0.102tonf）
• ・The maximum injecting pressure is attainable maximum set values. This value may be limited by molding conditions and cycle time.
• ・The maximum injecting speed is calculated values. This value may be limited by set injecting pressures.
• ・A large-sized screw may not be applicable to some kinds of material.