Toyo Si-30IV

Item			Si-30IV
	Injection unit type	-	B			CH			D
	Screw diameter	mm	16	18	20	20	24	28 *	20	24	28 *
	Theoretical injection capacity	cm3	13	18	23	23	43	59	23	43	69
I injection unit	Injection unit	-	-			-			D75B
	Max. injection speed	mm/s	-			-			300
	Max. injection pressure	MPa	-			-			274.5	235.4	182.3
II injection unit	Injection unit	-	B75B			-			D150B
	Max. injection speed	mm/s	300			-			-	300
	Max. injection pressure	MPa	254.9	254.9	235.2	-			-	274.5	235.2
III injection unit	Injection unit	-	B110B(BH150B)			CH150B			-
	Max. injection speed	mm/s	500			500			-
	Max. injection pressure	MPa	254.9 （254.9）	254.9 （254.9）	235.2 (235.3)	235.3	215.7	156.9	-
	Clamping force	kN	294
	Tie bar clearance (H×V)	mm	310 X 290

• ・The figures are subject to change without any legal obligation on the part of the manufacture.
• ・The specifications are expressed in SI units.（1MPa=10.2kgf/cm²、1kN=0.102tonf）
• ・The maximum injecting pressure is attainable maximum set values. This value may be limited by molding conditions and cycle time.
• ・The maximum injecting speed is calculated values. This value may be limited by set injecting pressures.
• ・A large-sized screw may not be applicable to some kinds of material.
• * For the φ28 screw specification, the machine requires some specially designed mechanical parts. The machine having shipped with a φ20 or a φ24 screw cannot accommodate a φ28 screw.