Toyo Si-130IV

Item			Si-130IV
	Injection unit type	-	D				F
	Screw diameter	mm	-	24	28	32	28	32	36	40	32	36	40	46
	Theoretical injection capacity	cm3	23	43	69	90	69	103	147	201	103	147	201	266
I injection unit	Injection unit	-	-				F75B				-
	Max. injection speed	mm/s	-				150				-
	Max. injection pressure	MPa	-				274.5	235.4	191.1	156.8	-
II injection unit	Injection unit	-	D150B				F200HB				F200B
	Max. injection speed	mm/s	300				300				210
	Max. injection pressure	MPa	-	274.5	235.2	181.3	274.5	250.0	196.0	161.7	264.0	250.0	215.6	166.6
III injection unit	Injection unit	-	D300B				-				-
	Max. injection speed	mm/s	500				-				-
	Max. injection pressure	MPa	-	274.5	235.2	181.3	-				-
	Clamping force	kN	1274
	Tie bar clearance (H×V)	mm	510 X 460

• ・The figures are subject to change without any legal obligation on the part of the manufacture.
• ・The specifications are expressed in SI units.（1MPa=10.2kgf/cm²、1kN=0.102tonf）
• ・The maximum injecting pressure is attainable maximum set values. This value may be limited by molding conditions and cycle time.
• ・The maximum injecting speed is calculated values. This value may be limited by set injecting pressures.
• ・A large-sized screw may not be applicable to some kinds of material.